Search results for query: *

Length is 70" Width 39" Height 74"

Never mind. I figured it out. The board has two connections one is flipped and the other is normal. Hooked up to the normal and all is good. It's always good to RTFM.

Just got done doing a recap on a Sanwa 1745 and am hooking it up to a different game. It was in a time crisis 3 and I'm putting it in an Area 51 max force. This monitor has a non-standard connector and I believe I have it hooked up correctly. It looks good but is just upside down. The old...

The LED blinks about once a second. I installed a fresh load, copied over the folder and ini config put them in the root directory and still when I go to configure the joystick it is not detected. could I have some of the switches wrong on the board? Here is a link to the USB cable I am...

I will work to get a better video tomorrow when its a little warmer.

I am going to do a fresh load of the mister software and will load the files again.

yes

https://media.giphy.com/media/dKvGX9LPTrBQOqwBWK/giphy-downsized-large.gif Attached is a video of it running. If I am looking at this right then yes it is blinking. Thank you for all the help

From your previous response. Hello, you need to flash the kernel system that supports DB15 to support DB15. How do I flash the kernel system that supports DB15? At the same time, you must use a 9-core USB3.0 data cable. Yes brand new 9-core USB3.0 cable I have installed the mister.ini files in...

Ok I tried the above and no change still does not recognize the joystick or buttons attached. I went and purchased snac to db15 and still does not work. Is there changes that need to be made now I have the snac module?

Thank you I will give it a try.

The post above is a couple of pictures of how I have it hooked up and the error. I went into the ini and un-commented the two lines but it did not make any differences. What am I missing. Thank you

the controller and buttons are attached directly to the Jamma.

A couple of questions What are the switches used for on the v185 board? Do you have to set one of the switches for two players? Thank you!

Finally got it hooked up into a cab looks like it is not detecting the joystick and buttons attached to the Jamma connector. The sound is good and the monitor needed some adjustment but not sure why the joystick and buttons don't work.

I got the pins fixed. Moving back to the board. I've attached a picture of C70 which is not connected. It has a very long leg, making me think it was never connected. I am thinking I will solder it down and see what happens.

You are the man! Thank you so much for the direction and help. I ran the memory test and it looks good. (It also shows you how bad the screen looks.) I did notice that C70 was only soldered on one end and the other end looks like it was never connected it attaches to chip 315-5306. I'll take a...

Thank you for spending the time to write this up! This is great info. The lines go through all of the background the objects like the heads up and the overlays look great. Looking at the schematics I can't find the line buffer RAM. Is this something that is easy to replace? Thank you again.

Just picked up a G-loc. The game plays fine but it has horizontal lines through the background. From what I have read this is a bad Rom. I see that you can get a Rom testing program for afterburner 2 will this work on G-loc as well? (not sure it works with the Y-board) Is there a schematic...