Recent content by k1701

Hello GoldenGlover, will try what you described and get back with findings, Thanks for responding

Hey , thanks for the response,was hoping it was a power supply issue, l still have the working Peter Chou supply and a new fan for it

Hello mathewbeall, thanks for the response, The 5v is tested at 5.1, l raised it to that level The A board I'm using as had no problems,the B board had no issues I tried the darksoft board with another CPS2 B boards, no issues I IMHO , that barring any issues with the A and B boards , the...

Hello everyone, l have a cps2 board with the darksoft champion edition installed. I had a Peter Chou power supply ,(USP-11-150X )wasnt working and installed and RetroArcade.us 16A Arcade Switching Power Supply, 133 Watt, 110-220V as well as a Gonbes 8200 vga adapter It was working properly...

Update, Hello nem, tDRG and notsonic. Been running the HNG 64 with no problems so far,voltage is ok , the rgb vga adapter is stable at the 480 resolution Once again thanks everyone!

Update, Hello all I got through with the rewiring of the mvs harness, I double checked all the connectors to make sure they correspond to the mvs connection order Everything is working! Thanks notsonic, and neo-alec!

Hello notsonic, thanks for the response,I checked out twisted quarter, the harness would have been perfect,no rewiring. I'm going to rewire a standard harness and rewire and triple check my harness I got from atomic market and see how it goes. I will check twisted quarter occasionally for when...

Hello Neo Alec,thanks for the response, the link you sent me is the same one from amazon, diy arcade. You're right I'll rewire a standard harness or recheck and rewire the aforementioned harness. Was hoping that there were other suppliers(that l wasn't aware of)of properly wired mvs harnesses...

Hello everyone ,was trying to find a neo mvs jamma harness for a Mv4 fs board,l got one from amazon...

Also tDRg and nem thanks for the help and season greetings!

Hello not sonic, thanks for the response, your questions got me rfocusing on the power supply and the rgb /vga adapter I tested the +5 and and readings were +5 I fired up the HNG64 again and saw that the video was cutting on and off, not crashing. Was definitely a adapter issue. I checked...

Hello nem,i measured the + 5 v,it was 5.1 at first then l adjusted it to 5.0 exactly

Hey,thanks for the response, l did wire up my 133 watt power supply, https://www.amazon.com/gp/aw/d/B07F1D1Q64?psc=1&ref=ppx_pop_mob_b_asin_title The game boots up with no problems, but when l coin up, and press buttons during gameplay,the game goes blank Also, I have a gbs 8200 rgb to vga...

Hello All,l recently acquired a HGN 64 fighting board ,l am uncertain of the wattage needed for the power supply. l have a 133 watt power supply in my cps 1, 2,3 and neogeo 1 slot which work with no issues. Also l have a 150watt supply in my neogeo mv4. I think with the l/O board in the HNG64...

Sir,l followed your instructions and was successful, thank you!