Recent content by stanleyyeh0205

Not sure if https://www.brookaccessory.com/detail/95441291/ is available where you are, it’s worth checking.

Thanks. I looked at it before. Since I am not really good at electronics, I prefer what’s available in the market. USB2DB15 is twice as expensive as Brook. I’ve talked to a few vendors on this forum, who mentioned that they will have something similar this year. We’ll see what happens.

Thanks for the confirmation. I totally overlooked the firmware update is mentioned on https://www.brookaccessory.com/detail/95441291/ . Brook looks like a good alternative to Undmaned due to its availability.

Brook told me that the converter only supports ABCD.

May we know if the converter takes kick harness?

Does anyone know if PS3/PS4 to NEOGEO Super Converter can take signal from USB hub to which a PS4 gamepad and zero-delay stcik are connected?

May I know if USB2DB15 CS ver. would take the USB signal from KVM that connects to zero-deley arcade stick and a USB HID so I can use either anytime I want?

May I know if USB2ARCADE would take the USB signal from KVM that connects to zero-deley arcade stick and a USB HID so I can use either anytime I want?

May I know how I can directly connect the zero-delay stick and buttons to JAMMA harness without USB decoder so the stick and buttons and used on PC and cabinet?

May I know how UD-USB Decoders are different from USB2DB15 and CS Ver. for JAMMA/NEO GEO? It appears to me that both perform the same job, which is to bridge usb controller and JAMMA/supergun.

Thanks. JAMMAFIER is literally a supergun, which can simplify my project. My initial research on the internet showed that there's no noticeable input lag caused by conmbination of Undamned USB decoder and zero-delay fightstick. I should be good to go.

I' think about an All-in-One / Multi-Purpose cabinet that can be shared with PS3/PC/JAMMA/JVS. Here's what I have in mind so far: Connect Zero-delay arcade stick and LCD monitor to KVM switch, JAMMA Harness to Undamned USB decoder (terminal block) * 2, arcade power supply, and GBS8200...

Any good luck? I'm looking for ways to share the arcade stick and monitor with PS4 and JAMMA boards.

I was just wondering if J-PAC can replace Capcom I/O board. Can anyone tell? What's the pupose of the USB and PS/2 port?

Can anyone suggest something lightweight like CPS2 JAMMA Standard Connector? I just can't find one anywhere. Looks like I just need a CGA to VGA adapter to complete my own supergun.