If the WiPi is still connected to your wifi network you can access it by the ip given by your router. If you successfully changed it back to hotspot mode you should finde the wipi network. - You can reset the network with a file you can put on the sd card - Please check the manual for the...
Check the Instruction Manual - There is a Link in the official Github (scroll down to the text) - Read Page 3 - There is an explaination how to setup the OSM (i called i OSD) for being available on reboot
It is good to slowly read through that manual, here are a lot of hidden gems/information in...
The OSD is part of the WiPi Image. You enable it and decide if you want to always load it. Imagine it as a Game which is loaded to the noami, but instead of a game you get a nice OSD. Be aware that not all OSD Game settings are "translated", since that takes time to figure out. - Regarding your...
- For the nfc cards you need a NFC Reader (should be around 20 USD) and some NFC cards - For each game you want to start you need one card. Cards can be written within the wipi gui - I think it is a nice option for a few selected games. There are nice 3D prints available.
- The OSD is superior...
In my humble opinion: The touch screen menu is the worst way to select games, since the menu is not really optimized for small screen. I guess you always could use one of those 7"-10" Touchscreens (but i guess those need some reconfiguration before working)
I first used an old ipad to select...
I got a ST-V from a friend, which is currently not working.
I found some missing / altered components on the pcb and would love to know why those were altered. Maybe some kind of mod i don't know of?
The board was working fine with those missing components - This is not a request for help on...
Some updates:
socketed chips (on the program board) is not a problem at all. Not sure what i did wrong, but it fits perfectly (and tight). No issue there!
i grinded down the pcb facing pillars on the bottom shell - Gap is not 100% gone, but much much better now! (no clue how much i have taken...
Finished printing the shell and it is a nice design! Thanks a lot!
printed with PETG 0.2, with support on screw holes with brim
Looks like i got minor bending (does not look like warping) in my print, which causes some gap issues - Will reprint it in PLA to check if the problem exists with...
You heat the inserts (f.e. with a soldering iron) and melt it into the plastic
- https://www.amazon.de/-/en/gp/product/B088QJG676 (M2 inserts)
- https://www.amazon.de/-/en/gp/product/B09BMK4BK1 (soldering tips for inserts)
View: https://www.youtube.com/shorts/J4Fz8DlwFyo
View...
- printing on a bambulab A1 @ 0.2 - slicer estimate was 6hrs, but i guess it is closer to 5-5.5hrs in total (for both sides!)
- the prusa mk3s is a very nice printer, but showing its "age" (=slower with same quality output)
- if your design is better than the old one i will have to reprint all...