Recent content by c1v1ta

damn, that's awesome! thanks for the info. can i ask if you're on OS2 or OS4? Curious if they have any 3D games in the pack (HOTD1-3, Time crisis 1-3, etc)

Awesome! What does your hardware setup look like? And how were you able to get everything going from a software perspective? Was it just plug-n-play? Curious about games too. Are you going MAME, console, or PCB?

Right, good question. The GunCon has two cables that come out: RCA video and USB. The USB can plug into the Pi, and I assume the Composite goes into the TV. ...Then where does the Pi composite go?

Quick bump on this one, thanks!

Hey guys, I have a CRT and would like to use it for a dedicated light gun multicade. Right now I’m thinking of using an RGB PI (OS4, ideally, so I can get more of the later 3D titles) with a 3.5mm to RCA cable. I also have a GunCon 2 already, with output to USB and composite video. The CRT...

Ah, got it. I'm puzzled, then. How can the same washer/shaft combo can work for @ImportantBet but not @notsonic ? ?(

This is super comprehensive. Thanks for putting this together! Really helpful to see just how the various sizes fit with each other. Looks like the JLF is too small for the newer LS-32-02. Were you able to try the Older LS-32 w/ JLF Dust Washer?

Damn, which is basically 10mm. Thanks, my friend! @nem you mentioned these wouldn't fit. Just wanted to double check here and see where the disconnect was coming from. Maybe the JLF washers are just a touch big for the JLF shafts but end up fitting snug on the LS-32s? Were you going solely on...

Wow, cool. Could I trouble you for a diameter measurement of either your LS-32 shafts or the opening circle of the dustwasher?

Haha! Is it really a bad stick? I have two NACs that both came with 2x LS-32s. The dust washers they came with were not original and looked pretty gross. Something 3D printed might be an option if I really can't find anything OEM, which is preferred! Is that something you do? I'm so confused...

If anyone comes back to this thread in the future: Here's the Sanwa JLF shaft diameter (8.85mm): And here's the Seimitsu LS-32 diameter (10mm): The JLF shaft is 1.15mm smaller in diameter than the LS-32, so any dust washer that would fit the JLF snugly will not fit on the LS-32. Based on...

Ah, ok. Sounds like I need to cancel an order then. I have standard LS-32 shafts. They look like they have about a 1cm diameter. Any recommendations for those, if not the JLF dust washers?

Thank you!

Just to confirm, the Sanwa JLF dust washers fit on the Seimitsu LS-32 shafts? I see recommendations, but want to clarify if this is something someone has actually tried.

thanks! are these effectively interchangeable with the 5380?